Ir a contenido

Arduino Nano 33 IoT

$643.00
SKU AD-BX027
Disponible : 10

El Arduino Nano 33 IoT es el modo más fácil y económico de mejorar los dispositivos existentes (y crear nuevos) para formar parte de la red IoT y diseñar aplicaciones pico-red. Ya sea que estés buscando construir una red de sensores conectada a tu oficina o router doméstico, o si deseas crear un dispositivo BLE que envíe datos a un teléfono celular, la Nano 33 IoT es la solución integral para muchas de estas aplicaciones básicas de IoT.

El procesador principal de la placa es un Arm® Cortex®-M0 32-bit SAMD21 de bajo consumo. La conectividad WiFi y Bluetooth® se realiza con un módulo de u-blox, el NINA-W10, un chipset de baja potencia que opera en el rango de 2.4GHz. Además de esto, se garantiza una comunicación segura a través del chip criptográfico Microchip® ECC608. Además, se puede encontrar una IMU de 6 ejes, lo que hace que esta placa sea perfecta para sistemas simples de alarma de vibración, podómetros, posicionamiento relativo de robots, etc.

Microcontroller SAMD21 Cortex®-M0+ 32bit low power ARM MCU (datasheet)
Radio module u-blox NINA-W102 (datasheet)
Secure Element ATECC608A (datasheet)
Operating Voltage 3.3V
Input Voltage (limit) 21V
DC Current per I/O Pin 7 mA
Clock Speed 48MHz
CPU Flash Memory 256KB
SRAM 32KB
EEPROM none
Digital Input / Output Pins 14
PWM Pins 11 (2, 3, 5, 6, 9, 10, 11, 12, 16 / A2, 17 / A3, 19 / A5)
UART 1
SPI 1
I2C 1
Analog Input Pins 8 (ADC 8/10/12 bit)
Analog Output Pins 1 (DAC 10 bit)
External Interrupts All digital pins (all analog pins can also be used as interrput pins, but will have duplicated interrupt numbers)
LED_BUILTIN 13
USB Native in the SAMD21 Processor
IMU LSM6DS3 (datasheet)
Length 45 mm
Width 18 mm
Weight 5 gr (with headers)

 

Batteries, Pins and board LEDs 

  • Batteries: the Nano 33 IoT has no battery connector, nor charger. You can connect any external battery of your liking as long as you respect the voltage limits of the board.
  • Vin: This pin can be used to power the board with a DC voltage source. If the power is fed through this pin, the USB power source is disconnected. This pin is an INPUT. Respect the voltage limits to assure the proper functionality of the board.
  • 5V: This pin outputs 5V from the board when powered from the USB connector. Note: for it to work, you need to short theor VBUS jumper on the back of the board. If you power the board from the VIN pin, you won’t get any regulated 5V and even if you do the solder bridge.
  • 3.3V: This pin outputs 3.3V through the on-board voltage regulator.
  • LED ON: This LED is connected to the 5V input from either USB or VIN.
  • I2C pins: As opposed to other Arduino Nano boards, pins A4 and A5 have an internal pull up and default to be used as an I2C Bus so usage as analog inputs is not recommended.

Reseñas

Based on 1 review Escribe una Reseña