LCD Nokia 5110 con Blacklight Azul
The Nokia 5110 is a basic graphic LCD screen for lots of applications. It was originally intended to be used as a cell phone screen. This one is mounted on an easy to solder PCB.
84 X 48 dot matrix LCD,can show 4 lines of characters
Use serial interface communicate with the master processor, the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU, such as the AVR,PIC,STM32,STC MSP430 and so on. Transfer rate up to 4Mbps, can full speed write display data without waiting time.
Can use the conductive glue to connect the module with the printed board, without connecting cable.The metal hooks on the module can fix the module on the printed board, which is very easy to install and replace.
Low power supply,the working current in normal situation is lower than 200μA,and has power-down mode
Disposición de pines
- RST - Reset
- CE - Chip Select
- DC - data/instruction selection
- DIN - serial data line
- CLK - Serial Clock Line
- VCC - power input (3.3v or 5v)
- BL - backlight control 8. GND - Ground"
- Power supply voltage: 2.7V-3.3V
- Data interface level: 2.7-3.3V
- Backlight power supply voltage: highest 3.3V